English paper piecing is a slow stitch artform.
But what if you could speed up the process? At least the cutting process.
I tried using the xTool M2 to cut out the paper templates and the fabric hexagons for English paper piecing (EPP).
In this tutorial, I'll show you how I did it.
CUTTING OUT ENGLISH PAPER PIECES WITH THE XTOOL M2
Learn how to cut pieces for English paper piecing quickly and easily with the xTool M2 laser cutting machine.You can see my review of this machine here.
↑ ↑ ↑ PIN IT ↑ ↑ ↑
This post may contain affiliate links. As an Amazon Associate I earn from qualifying purchases. Please see my full disclosure policy for details.
SUPPLIES NEEDED
- XTool M2 Laser Machine
- fabric
- cardstock
- Hexagon file - this is specifically for xTool
HOW TO USE THE XTOOL M2 TO CUT PAPER AND FABRIC FOR EPP
The most basic form of English paper piecing is hexagons.Cutting out the pieces can be tiresome. So I decided to try it with the M2.
CUTTING THE CARDSTOCK
First, open the 1.5 Hexagon file in xTool.
Stack up to 3 pieces of cardstock and secure to the base of machine with masking tape.
Connect the laser machine, select the lasering on flat surface mode, and choose white cardstock for the material. (The color you cut doesn't actually matter.)
When you close the lid of the machine, it will take a picture. Move the hexagons to fit in the cutting area.
I used the recommended settings to process the cut.
Once pieces are cut, the air assist on the machine will blow the pieces around.
I found that it mostly moved the pieces out of the path of the laser.
In this run, I only had one casualty.
I used a handheld vacuum to remove all the small circles from the baseplate of the machine.
CUTTING THE FABRIC
Next it's time to cut the fabric.
Using a charm pack (5 inch squares) is perfect to cut out the four 2.5 inch hexagons.
The process is the same. Secure 4 layers of fabric to the baseplate of the machine with masking tape.
Change the material setting to cotton fabric.
Close the lid and again adjust the hexagons to be aligned over the fabric and begin the cut.
It's pretty slick. With four layers of fabric and cutting four hexagons at a time, I was able to get 16 fabric hexies in one pass.
Repeat as many times as needed to get the desired number of hexagons.
Once you are done, there will be some residue in the bottom of your machine. I take a damp paper towel and scrub it away. Then I dry it with a paper towel.
I've found if I do this regularly after each project has helped me keep my machine clean.
One thing to note. The laser is burning in order to cut. There will be some burn marks on the edges of your pieces.
This doesn't bother me for EPP because the edges will all be folded underneath and out of site in the finished product.
Want to learn how to use these pieces? I'll be creating an English paper piecing tutorial soon.
In the meantime, you can check out this Hexie flower pattern. It's 25% off this week only!
This pattern is perfect for those who want to dip their toes in English paper piecing, but are overwhelmed by a whole quilt made entirely with EPP. This quilt requires just 12 hexie flowers to be made.
(Unfortunately, I have not created an xTool file for this size, so they will have to be cut out by hand.)
MORE LASER PROJECTS
- Laser Engraved and Cut Bookmarks from Leather
- Laser Cut Drawer Organizer (Drawer fronts made from old book covers!)
- Laser engraved wooden lids for candles
Don't forget to pin it!!













0 comments